4-18
Security 15088:J 10/22/99
The following system requirements are illustrated in Figure 1.3-10. See Table 1.1-1 in the introduction to this
section for monitor and control module options.
• One AM2020/AFP1010 Protected Premises Unit (PPU)
• One AM2020/AFP1010 Central Station Unit
• One Security Supervisory Protected Area
• One Protected Premises
• System Arm/Disarm Capability with Central Station Ringback Signal
• The minimum security equipment required is as follows:
— SIB-2048A or SIB-NET Interface
— NIB-96 Network Interface
— STS-1 Security Tamper Switch
— Monitor Modules
— RKS-S Remote Keyswitch
— ACM-16AT or ACM-32A Remote Annunciator for Entry or Exit Door
— Control Module
— RA400Z Remote Annunciator
— Security Devices
— One Group Interface
www.PDF-Zoo.com
To Next Page
Loading...
