Nu-Vu OP-2FM - ABOUT YOUR OP-2 FM; Product Overview

OP–2FM OWNER'S MANUAL ABOUT YOUR OP–2FM
NU–VU® FOOD SERVICE SYSTEMS PO BOX 35 MENOMINEE, MICHIGAN 49858-0035
(800) 338-9886 SALES FAX (906) 863-5889 • SERVICE FAX (906) 863-6322 page 1
ABOUT YOUR OP-2FM
The NU-VU
®
OP-2FM is an electrically powered and operated commercial baking/cooking appliance. It
does not require exterior venting under normal circumstances; however, hood and venting codes vary from
country to country, state to state, and even from locality to locality. For this reason, NU-VU
®
cannot give
specific detailed information regarding your individual application. Your local building inspector, licensed
contractor, or installer is best qualified to determine your specific needs.
The oven section features our patented V-AIR
®
air movement system. A top-mounted blower moves the
heated air down through the oven side walls to be heated, then out through specially designed hole patterns
to provide even heat distribution throughout the oven. Your product is baked evenly top to bottom, side to
side, and front to back without turning pans. You can load the oven completely with pans having the same
product, bake, and remove the entire load at the same time. The bake is uniform because each shelf now
receives essentially the same air pattern.
The oven section is equipped with a single 550
°
F solid state heat control and a 60-minute timer. The half-
size pans are supported by the side walls. No separate oven shelves are required.
The proofer section uses a 250
°
F solid state heat control, a numbered 1-10 humidity control, and a 60-
minute timer. Manual-fill proofers are supplied with a stainless steel water pan. The side walls support the
nine (9) chromed wire shelves supplied with the unit.
The NU-VU
®
OP-2FM is designed for the following:
• Automatic pan positioning • Dependability
• Rapid and even baking • Low energy consumption
• Easy cleaning • Low maintenance
• Simple operation • Rapid servicing
The OP-2FM is constructed of stainless steel inside and outside. All of the frame members are welded to
provide lifetime durability, rigidity and long life construction. Components such as temperature and
humidity controls, timers, switches, motors, heating elements, and others are thoroughly tested before
shipment. Ongoing research and development projects are used to introduce the latest and most
dependable parts.
The NU-VU
®
OP-2FM is available with the AUTOMIST proofer option. This option eliminates the
manually-filled water pan. An adjustable controlled water mist is injected into the blower wheel. The
blower wheel then distributes this water mist evenly throughout the proofer. The injected mist provides the
controlled humidity necessary for proper proofing action.