SERVICE AND REPLACEMENT GUIDE OP–2FM OWNER'S MANUAL
NU–VU® FOOD SERVICE SYSTEMS PO BOX 35 MENOMINEE, MICHIGAN 49858-0035
page 40 SALES FAX (906) 863-5889 • SERVICE FAX (906) 863-6322 (800) 338-9886
D. Make sure that any washers provided with each replacement Hinge are installed on the pivot pin
between the Hinge halves. Position the Door so that the sleeve of the top half of each Hinge is
centered over the end of the pivot pin on the bottom half of each Hinge. Lower the Door onto
the pivot pins. Work the Door back and forth to fully seat the Hinges.
E. Test the Door for proper closing and sealing (refer to the DOOR TEST PROCEDURE).
DOOR GASKET, How To Replace:
Follow these instructions to correctly install your Door Gasket with minimal problems. Use the
installation kit provided. If you have any problems or questions call NU-VU
®
at (800) 338–9886 and
ask for the Service Department.
A. Remove all pieces of the old Gasket. Thoroughly clean the Door frame in the area of the new
installation. Remove the old sealant and any baked-on deposits.
B. Pre-cut the replacement Gasket to a size slightly longer than you require.
C. Put a small amount of soap water into and around the slot that the new Gasket will fit into (a
small trigger spray bottle works well). This step is optional but will help in the installation.
D. Position the new Gasket over the slot, allowing the ends to extend past the end of the slot. Press
the mounting flange down into the slot on the Door frame. Use a roller tool to force the mounting
flange into the slot by working the tool back and forth along the Gasket. Make sure the Gasket
mounting flange is completely fitted into the slot and that the Gasket is free to slide back and
forth in the slot.
IMPORTANT: DO NOT DISASSEMBLE THE ACTUAL DOOR WHEN REPAIRING
OR REPLACING THE DOOR GASKET!
To Next Page
Loading...
