NXP Semiconductors LPCXpresso54608 - Feature summary

NXP Semiconductors
UM11035
LPCXpresso boards for LPC546xx/LPC540xx/LPC54S0xx families of
MCUs
UM11035
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2017-2019. All rights reserved.
User manual
Rev. 2.1 — 7th January 2019
4 of 36
Fig 1. LPCXpresso546x8/540xx/54S0xx underside view
This document describes the hardware of the LPCXpresso546x8/540xx/54S0xx boards,
plus information on the CAN-FD shield supplied in the OM13094 kit (this shield board is
also available as a standalone product, order code OM13099.) This shield board can be
used with any of the LPCXpresso boards described, but note that the LPCXpresso54608
does not support CAN-FD.
The following aspects of interfacing to the board are covered by this guide:
• Main board features.
• Setup for use with development tools.
• Board interface connectors.
• Jumper settings.
2. Feature summary
The LPCXpresso546x8/540xx/54S0xx board includes the following features:
• On-board, high-speed USB based, Link2 Debug Probe with CMSIS-DAP and
SEGGER J-Link protocol options:
 Link2 probe can be used with on-board LPC546x8/540xx/54S0xx or external
target.
 UART and SPI port bridging from LPC546x8/540xx/54S0xx target to USB via the
on-board Debug Probe.
 Support for external Debug Probe.
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.