NXP Semiconductors PN7462AU - Page 43

NXP Semiconductors
UM10883
PN7462 family Quick Start Guide - Development Kit
UM10883
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2018. All rights reserved.
User manual
COMPANY PUBLIC
Rev. 1.6 — 14 May 2018
319816
43 of 120
Parameter
Meaning
Example value
protocolType
Defines the used protocol and bit rate
RM_A_106
Table 4. Send Data input
Parameter
Meaning
Example value
shortFrame
Enables a short frame (e.g. for REQA)
YES
rxCRC
Enables the CRC check for the card response
NO
txCRC
Enables the CRC on the TX data
NO
timeOutInUs
Defines the time out of the test command in µs
1000
Byte(s) to be sent
These bytes are sent.
0x26
Table 5. Read Data input
Parameter
Meaning
Example value
invertedMaskBytes
Allows to mask certain bytes (for e.g. the PUPI) in
the card response
0x00, 0x00
Bytes to be received
These bytes are checked as Rx data
0x44, 0x03
Optional, if AWG is connected:
<VoltageLevel minValueInmV="100" maxValueInmV="2000" stepSizeInmV="500"/>
Defines the LMA voltage level of the AWG from minimum to maximum value with given
step size.
Register settings:
<Parameter name="Rx Gain" minValue="0x01" maxValue="0x03"
registerAddress="0x40004110" bitPosition="0" bitLength="2" />
<Parameter name="Rx HPCF" minValue="0x00" maxValue="0x03"
registerAddress="0x40004110" bitPosition="2" bitLength="2" />
<Parameter name="MinLevelP" minValue="0x00" maxValue="0x0F"
registerAddress="0x400040b4" bitPosition="8" bitLength="4" />
<Parameter name="MinLevel" minValue="0x00" maxValue="0x0F"
registerAddress="0x400040b4" bitPosition="12" bitLength="4" />
Defines the register bits from minimum to maximum. Any accessible register can be
used.
Example scripts refer to 11 and find under
c:\nxp\NxpNfcCockpit_v<VERSION>\cfg\RxMatrix\RxMatrix_PN7462AU\