PN7462 family Quick Start Guide - Development Kit
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2018. All rights reserved.
User manual
COMPANY PUBLIC
Rev. 1.6 — 14 May 2018
319816
Fig 67. Connecting LPC Link2 to the PNEV7462B board
When debug is started, the application is automatically downloaded to the target and it´s
programmed to the flash memory; a default breakpoint is set on the first instruction in
main (), the application is started (by simulating a processor reset), and code is executed
until the default breakpoint is hit.
To start debugging your application on the PN7462AU, simply highlight the project in the
Project Explorer and then in the Quick start Panel click Debug, as shown in Fig 68. The
MCUXpresso IDE will first build application and then start debugging.
LPC-LINK2
External power
supply
USB LPC
LPC1769 µHost
PN7462AU DUT
USB PN74 62AU
To Next Page
Loading...
