Scanning 31
■ Edit
■ Frame
■ Pause
■ Stop
More detailed information on the buttons is given below:
File/Print/Print+File This button will appear, when on the Control window in
the Running Mode entry box Single, Hollerith Check or Auto Feed, is selected.
The button allows you to accept the scanned image and generate the desired
output. The card is ejected into the output hopper and the system returns to the
Control window.
Continue This button will appear in three cases:
1 when on the Control window in the Running Mode entry box Batch is selected
2 when on the Control window in the Output Mode entry box View is selected
3 after selecting pause in stead of File/Print/Print+File
Reject This button rejects the scanned image. No output is generated and the
system returns to the Control window. The card is ejected from the scanner.
Rescan Should the image not be optimal from the first time, you can change
the imaging parameters and scanning resolution and then rescan the card to
obtain a better result.
Accept In Hollerith Check mode, this button is used to accept the displayed
Hollerith code.
Edit This button allows you to correct errors in the Hollerith coding. The
Hollerith Check window will appear to make the corrections.
▼ To edit the Hollerith data:
1 Click Edit in the Run-Time Display window.
The Hollerith data string as read from the card is displayed. You can edit the
name for the scanned file and the drawing size settings in the entry fields.
To Next Page
Loading...
