Print Controller User’s Guide 4-13
Chapter 4 Control Panel Setup
[Copier Time Out]
Select [Copier Time Out] to set the Copier Timeout value. When it reaches the Copier
Timeout value after operations for copy on the control panel of the main body printer,
the print controller can receive the print job data.
Setting values are as follows:
• 15 / 30 (Default) / 60 / 90 (unit: seconds)
[Scan Data AutoDel.]
Select [Scan Data AutoDel.] to set the Scan Data AutoDel. condition.
Setting values are as follows:
• Del After 24H: The scan data held in the print controller’s hard is automatically
deleted after 24 hours (Default)
• Off: The scan data held in the print controller’s hard is not deleted automatically
To Next Page
Loading...