Oce 75 - To Scan Documents in Store Mode

5-6 Print Controller User’s Guide
Chapter 5 Scanner Operation
● To Scan Documents in Store Mode
The scanned data is sent to the print controller after canceling store mode.
You can use the Store Mode to sent the scanned data of multiple originals at once.
1. Complete steps 1 through 5 under the heading “To Scan Documents in Real
Mode”.
2. Press the [STORE] key in the scanning setting basic screen.
3. Press the [START] button so the original document you’ve set on the platen
glass or RADF is scanned depending on the current scanning settings.
At this point of the process, no data is sent to the print controller.
4. Press the [STORE] key, and press the [START] button to send the scanned data
to the print controller.