Secure protocols
Enable IPSec
Introduction
IPsec is a security protocol that you can use:
■
to limit the access to your network to a maximum of 5 hosts.
■
to encrypt the data between these hosts and the system.
You can enable IPSec in the Océ Express WebTools. For more information on IPSec,
consult the Security manual.
Note:
Make sure your configuration is correct. You may not be able to connect to the printer
as a result of an invalid configuration. In this case, you can disable 'IPsec' on the user
panel ('System' - 'Setup' - 'Security').
Enable IPSec
1.
Go to 'Configuration' - 'Connectivity' - 'IPsec'.
2.
Click .
3.
Click 'Enabled'.
Chapter 4 - Define your workflow with the Océ Express WebTools 107
Enable IPSec
To Next Page
Loading...
Need help?
General