Oce PlotWave 300 - Disconnect the Network Cable and the Mains Supply Cable

Disconnect the network cable and the mains supply cable
Attention:
Make sure the main power switch (A) is in 'off' position.
1.
Disconnect the network cable from the network connection at the back of the printer (at
the right).
2.
Disconnect the 'Power' cable form the wall socket.
3.
Disconnect the other side of the 'Power' cable from the power connection at the back of
the printer (B) (on the left).
A
B
Chapter 6 - Maintain the printing system232
Disconnect the network cable and the mains supply cable