Printer configuration 69
Note: To activate the new IP settings you must restart the Océ VarioPrint 2090.
When to do
■ Before you try to print, make sure that you complete these TCP/IP settings
to connect to the Océ VarioPrint 2090 to the network.
Before you begin
Start the Océ VarioPrint 2090 Settings Editor in your web browser in the
system administrator mode (see ‘Access the Océ VarioPrint 2090 Settings
Editor in system administrator mode’ on page 12).
Attention: If you change any of the settings above, you can only access the
Océ Smart Imager through these new settings. If you make the wrong
settings, you cannot reach the Océ VarioPrint 2090 on the network (you
cannot start the Océ VarioPrint 2090 Settings Editor). You have to call for
service.
Attention: If you change the TCP/IP settings, you must restart the Océ
VarioPrint 2090 to activate the new settings. If you do not complete all
TCP/IP settings before this restart, you cannot reach the Océ VarioPrint
2090 on the network (you cannot start the Océ VarioPrint 2090 Settings
Editor). You have to call for service.
IP address The physical address of the Océ Smart Imager connected
to the TCP/IP network.
The Océ Smart Imager must have a unique IP address
within your network.
The IP address has four sets of numbers separated by
periods. Default IP address is 192.1.1.1
Subnet mask A method to divide the networks into smaller groups, or
subnets (segments).
The mask is a binary pattern that matches the IP address.
The Océ Smart Imager compares the subnet mask with a
network address number. Default value is 255.255.255.0
Default gateway The physical address on this subnet of the default
gateway connected to the TCP/IP network. Default value
is 192.1.1.2
Identification setting
To Next Page
Loading...
