Oce VL3200x - Using the Océ Installer Application on the CD-ROM to Configure Your Machine for a Wireless Network

Configuring your machine for a wireless network
35
3
LCD messages when using the SES/WPS/AOSS™ control panel menu 3
(Windows
®
)
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please choose Install Multi-Function Suite
from the CD-ROM menu.
(Macintosh)
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please choose Start Here OSX from the
CD-ROM menu.
Using the Océ installer application on the CD-ROM to configure your machine
for a wireless network 3
For installation, see Wireless configuration for Windows
®
using the Océ installer application in Chapter 4 and
Wireless configuration for Macintosh using the Océ installer application in Chapter 5.
LCD shows Connection status Action
Setting WLAN
Searching or accessing the access
point, and downloading settings from the
access point.
—
Connecting SES
Connecting WPS
Connecting AOSS
Connecting the access point. —
Connected Connection succeeded. —
Connection Error Session overlap has been detected.
Check that only one router or access point has
the automatic wireless setup
(SecureEasySetup™, AOSS™, etc.) mode
enabled and try starting from step c again.
No Access Point The access point detection failed.
Move the machine closer to your access
point/router and try starting from step c again.
Connection Fail Connection failed.
1 Try starting from step c again.
2 If the same message continues, reset the
machine back to the factory settings and try
again.