Oce VL3200x - Ad-hoc Wireless Configuration (Windows); Configuring Wireless Settings (Ad-hoc)

Wireless configuration for Windows
®
using the Océ installer application
51
4
Configuration in Ad-hoc mode 4
Before configuring the wireless settings 4
IMPORTANT
• The following instructions will install your machine in a network environment using the Océ installer
application for Windows
®
found on the CD-ROM we have provided with the machine.
• You can also setup your machine using the machine’s control panel which we recommended. See
Configuring your machine for a wireless network on page 19.
• If you have previously configured the wireless settings of the machine, you must reset the network LAN
settings before you can configure the wireless settings again. Press Menu, 7, 0 for Network Reset,
press 1 for Reset and then choose 1 for Yes to accept the change. The machine will restart automatically.
• If you are using Windows
®
Firewall or a firewall function of anti-spyware or antivirus applications,
temporarily disable them. Once you are sure that you can print, configure the software settings following
the instructions.
Configure the wireless settings 4
a Plug the machine’s power cord into the AC power outlet. Turn on the machine’s power switch.
b Press Menu, 7, 2, 7. Using a or b, choose On and press OK.
72.WLAN
7.WLAN Enable
a On
b Off
Select ab or OK
c Turn on your computer.
Close any applications running before configuration.
d Put the supplied CD-ROM into your CD-ROM drive. The opening screen will appear automatically.
Choose your language.