Oce VL3200x - 4 Wireless configuration for Windows using the Océ installer application; Windows Wireless Setup: Infrastructure Mode

36
4
4
Configuration in Infrastructure mode 4
Before configuring the wireless settings 4
IMPORTANT
• The following instructions will install your machine in a network environment using the Océ installer
application for Windows
®
found on the CD-ROM we have provided with the machine.
• You can also setup your machine using the machine’s control panel which we recommended. You can find
instructions in the supplied Quick Setup Guide or see Configuring your machine for a wireless network
on page 19.
• You must know your wireless network settings before you proceed with this installation.
Make sure you take notes on all the current settings such as SSID, authentication and encryption of your
wireless network environment. If you do not know them, contact your network administrator or the
manufacturer of your access point/router.
Check and record the current wireless network settings.
1
Pre-Shared Key (PSK) lets the Océ machine associate with access points using TKIP or AES encryption. Pre-Shared Key is 8 or more
characters in length, up to a maximum of 63 characters.
Wireless configuration for Windows
®
using the Océ installer application
4
Network name:(SSID, ESSID)
Communication Mode Authentication method Encryption mode
Network key
3
Infrastructure Open system
WEP
2
NONE —
Shared key
WEP
2
Pre-Shared Key
1
(WPA/WPA2-PSK)
AES
TKIP
LEAP CKIP
EAP-FAST/NONE
EAP-FAST/MS-CHAPv2
EAP-FAST/GTC
AES
TKIP