60
RESET FEATURE
This dive computer is configured with a RESET feature that
allows data to be cleared, including Nitrogen and Oxygen
calculations, FO2 set point, Log Mode entries, and
Downloadable data.
RESET PROCEDURE:
• While in SURFACE MODE (new activation period or after
a 10 minute post dive surface interval), press the Advance
(Front) button 1 time to access PLAN MODE.
• While 30 feet (or 9 meters) is displayed in the PLAN
MODE, press and hold Both buttons until SET 2 appears,
then release the buttons.
• Press and release the Advance (Front) button to display the
Clear screen (Fig. 65). The first 2 digits of the KEY CODE
flash.
• To change the number, press and release the Select (Side)
button to increase the digits to 01.
• Press and release the Advance (Front) button again to
display the second 2 digits of the KEY CODE, flashing.
• To change the number, press and release the Select (Side)
button to increase the digits to 01.
• Press and release the Advance (Front) button to complete
the RESET operation and turn the unit OFF.
WARNING: Reset
after a dive and
subsequent use
for a repetitive
dive conducted
by the same diver
could result in
serious injury to
or death.
Fig. 65 - User Set Gauge Mode
To Next Page
Loading...
