76
Surfacing from a Simulated Dive
• The Simulator will enter Demo Surface Mode (Fig. 88)
upon ascending to 3 feet (1 m) or shallower.
• Press and hold the Select (Side) button for 4 seconds to
access Time Acceleration. The small Time clock icon will
begin flashing.
• Press and release the Select (Side) button to increase
Surface Interval Time 1 minute per real time second.
• Press and release the Select (Side) button during the Time
Acceleration to restore the normal time rate of 1 second
per second.
• FO2 can be set after a Surface Interval of 10 minutes.
Press and release the Advance (Front) button to access
FO2 Set Mode. The FO2 graphic and value previously set
will appear with the value flashing.
• Press and release the Select (Side) button to increase the
FO2 value in increments of 1%.
• Press and release the Advance (Front) button to accept the
setting and return to Demo Surface Mode.
• To make another dive, press/hold the Select (Side) button
for 2 seconds to access Dive Mode for a repetitive dive.
The DOWN Arrow will appear flashing.
• Pressing and holding both buttons simultaneously for 2
seconds will revert operation to real Surface Mode.
Fig. 88 -Demo Surface Mode
To Next Page
Loading...
