OHAUS Explorer EX1241 - GLP and GMP Data; GLP Data Sub-Menu; Header; Balance Name

EN-114 EXPLORER BALANCES
5.9 GLP and GMP Data
Enter this menu to set the Good laboratory Practices (GLP) data.
5.9.2 GLP Data Sub-menu
5.9.3 Header
Enables the printing of GLP headings. There are up to 5 headings available.
Alphanumeric settings up to 25 characters are available for
each Header setting. .
5.9.4 Balance Name
Set the balance identification.
Alphanumeric settings up to 25 characters are available. The default setting is
blank.
5.9.5 Project Name
Enter this menu to set the Project identification.
Alphanumeric settings up to 25 characters are available. The default setting is blank.
5.10 Communication
Enter this menu to define external communication methods and to set printing
parameters.
Data may be output to either a printer or PC (See Section 5.9.8 for output samples.)
Factory default settings are shown in bold.
Notes: The COM3 menu is only available if the optional Interface is installed.
5.10.1 Communication Sub-menu
RS232
Standard
USB
Save to USB
flash drive
There are two types of USB interfaces on the Explorer:
Type A
Use this interface to transfer weighing data directly to a USB flash drive.
See the following 5.10.13 Save to USB flash drive for detailed instructions.
Mini-B
Use this interface to connect the balance to a computer or printer.
Choosing an item brings up another menu level (RS232 shown):
Device Settings
Print Settings
Label Printing
Choosing a Settings item brings up yet another menu level; the device settings are dependent on the
COM chosen (RS232 shown)