EN-116 EXPLORER BALANCES
ON = values are printed only when the stability criteria are met.
Print Numeric Value Only
Set the printing criteria.
OFF = All data values are printed
ON = Only numeric data values are printed
Print Options
Set the way to print.
Printer = Print the result through a printer.
PC = Transfer the result to a computer.
5.10.7 Auto Print
Set the automatic printing functionality.
OFF = disabled
ON STABLE = printing occurs each time the stability criteria are met.
INTERVAL = printing occurs at the defined time interval.
CONTINUOUS = printing occurs continuously.
When ON STABLE is selected, set the conditions for printing.
LOAD = Prints when the displayed load is stable.
LOAD ZERO = Prints when the displayed load or zero reading is stable.
When INTERVAL is selected, set the time interval using the numeric keypad.
Settings of 1 to 3600 seconds are available.
5.10.8 Print Calibration Data
Set the automatic Calibration Data printing functionality.
OFF = disabled
ON = enabled
5.10.9 Print Content
Enter this sub-menu to define the content of the printed data.
See details below:
Header
Set the status.
OFF = the user defined header is not printed.
ON = the user defined header is printed.
USER DEFINED TEXT
USER DEFINED TEXT
USER DEFINED TEXT
USER DEFINED TEXT
USER DEFINED TEXT
Note: The header information must be defined
using the H x “text” interface command.
(See Section 5.1.)
Date and Time
Set the status.
OFF = the time and date are not printed.
ON = the time and date are printed.
Application Name
Set the status.
OFF = the Application Name is not printed.
ON = the Application Name is printed.
Sample Name
Set the sample name.
OFF = the Sample Name is not printed.
ON = the Sample Name is printed.
Batch ID
Set the batch ID
OFF = the Batch ID is not printed.
ON = the Batch ID is printed.
Application Name: XXXXXXXXXXXX
Sample Name: XXXXXXXXXXXX
To Next Page