EN-142 EXPLORER BALANCES
TABLE 9-1. SPECIFICATIONS
Readability d, fine range
Readability d, full range
Repeatability (sd.), ≤5% of full load
Repeatability (sd.), 5% of full load to
fine range max
Repeatability (sd. ), fine range max to
full range
Linearity deviation, typical
Verification interval, e
(EX…M.. model only)
Approval Class
(EX…M.. model only)
Span Calibration Points (g)
g, mg, ct, oz , ozt, dwt, Grain, mom, msg, tical, tola, baht, Custom Unit 1, Custom Unit 2, Custom Unit 3
Weighing units* (EX…M.. model)
Weighing, Parts Counting, Percent Weighing, Check Weighing, Dynamic Weighing, Filling, Totalization,
Formulation, Differential Weighing, Peak Hold, Density Determination, Pipette Adjustment, Statistical
Quality Controll, Fill Weight Variation
Stabilization time (typical)
0.1 mg: ≤2 seconds, 0.01 mg: ≤8 seconds
Sensitivity Temperature Drift
Min-Weight (typical)
(USP, K=2, U=0.10%)
Min-Weight (optimal)
(USP, K=2, U=0.10%, SRP≤0.41d)
Full-Color VGA Graphic LCD
5.7 in / 14.5 cm (diagonal)
4-wire resistive touch screen
AC Adapter Input: 100-240 VAC 0.6A 50-60 Hz
AC Adapter Output: 12 VDC 1.5A
Terminal Housing dimensions
(W x D x H)
195 x 155 x 68 mm
7.7 x 6.1 x 2.7 inch
Base Housing dimensions
(W x D x H)
230 x 260 x 350 mm
9.1 x 10.2 x 13.8 inch
Assembled dimensions
(W x D x H)
230 x 393 x 350 mm
9.1 x 15.5 x 13.8 inch
Shipping dimensions
(W x D x H)
632 x 467 x 640 mm
24.9 x 18.4 x 25.2 inch
Note 1: M = EC Type approved
Note 2: Default Calibration weights shown in Bold
Note 3: * Availability is dependent on region.