OHAUS TP4KD - Percent Weighing

15
Percent WeighingPercent Weighing
Percent WeighingPercent Weighing
Percent Weighing
Percent weighing permits you to place a
reference load on the balance, then view
other loads as a percentage of the refer-
ence. The load you place on the pan as a
reference may be displayed as any per-
centage you select from 5% to 100% (in
1% increments). One hundred percent
does not necessarily have to represent
the reference load. Subsequent loads,
displayed as a percentage of the refer-
ence are limited only by the capacity of
the balance.
To perform percent weighing, use the
following procedure:
1. Repeatedly press
until PCT
CON is displayed.
2. Place an empty container on the pan
(if one will be used).
3. Press
.
4. SEt xxx will be displayed where xxx is
the current reference percentage.
5. The reference percentage can be
changed to any value from 5 to 100.
Press
to change the value.
(Pressing and holding causes
the display to increment quickly.)
Percent Weighing Default SettingsPercent Weighing Default Settings
Percent Weighing Default SettingsPercent Weighing Default Settings
Percent Weighing Default Settings
% Mode................................ Disabled
% Alternate Display ........... TOTAL %
Reference % ............................. 100%
EXAMPLEEXAMPLE
EXAMPLEEXAMPLE
EXAMPLE
A 10g reference load is set for 20%:
• A subsequent load of 100 g will be
displayed as 200%.
• A subsequent load of 200 g will be
displayed as 400%.
MODEMODE
MODEMODE
MODE
MODEMODE
MODEMODE
MODE
ONON
ONON
ON
TARETARE
TARETARE
TARE
MODEMODE
MODEMODE
MODE