42641101TH Rev.1 55 /
Oki Data CONFIDENTIAL
LEDStatus level
Table 5-1 (2/5)
Varies
Varies
Varies
Varies
or Blink
Varies
or Blink
Varies
or Blink
Varies
or Blink
Varies
or Blink
Varies
Blink
Varies
Varies
Varies
Varies
Varies
Varies
Varies
Light
Warn-
ing
Warn-
ing
Warn-
ing
Normal
Normal
Normal
Normal
Normal
Warn-
ing
Warn-
ing
Warn-
ing
Warn-
ing
Warn-
ing
Warn-
ing
Warn-
ing
Warn-
ing
Warn-
ing
Error
LCD
■
TONEREMP
■
TONERSNS
■
CHG DRUM
PRINT
DEMO
PRINT
FONTS
PRINT
MENU MAP
PRINT
FILELIST
PRINT
CLEANING
INVALID
DATA
■
ERR PSE
■
tttt EMPTY
■
TRAY2 COVER OPEN
■
FILE SYSTEM IS FULL
■
FILE IS WRITE
PROTECTED
■
INVALD ID.JOB
REJECTED
■
LOG BUFFER FULL.
JOB REJECTED
■
FILE OPERATION
FAILED nnn
MANUAL
mmmm REQUEST
Descroption
Toner near empty. (This state occurs after printing 100 sheets from
TONERLOW.)
Displayed combined with other messages in the first line.
Not displayed when “CHG DRUM” for drum life is displayed,
however. Possible to cancel print job or continue normal operation.
Something is wrong with the toner sensor. Displayed combined
with other messages in the first line when the engine is set to
Shipping mode. Normal operation is possible.
Error, explained later, is displayed when the engine is set to
Factory mode.(ERR 163)
Drum cartridge life (Warning). Displayed combined with other
messages of the first line.
TONER EMP ERROR status code is set to 10969 in the state of
warning which has restored temporarily CHG DRUM ERROR
(40996) when the drum life has occurred at the same time by
cover open/close presses "ON-LINE" switch.
A status code is set to 10060 in the state of CHG DRUM inde-
pendent warning.
Demo page printing.
Fonts sample printing.
Menu map printing.
File list printing.
Cleaning page printing.
Received invalid data. Prompts the user to press ON-LINE switch
to clear Warning display. Displayed when the printer receives an
unsupported PDL command.
Interpreter detects an error due to following reasons.
Data received after this is ignored till the end of the job.
When the job is received completely, this is automatically cleared.
- The job has a grammatical error.
- The page is complicated, and VM was used up.
Tray tttt has run out of paper. Handled as Warning until the user
designates the tray that has run out of paper. * Scroll display
Second Tray Cover Open
* Scroll display
Flash Full has occurred. This is a transient warning.
Displayed until the job is completed, then, cleared. * Scroll display
An attempt to write in a write-protected file was made.
Because this is a transient warning, it is displayed until the job is
completed. then, cleared. * Scroll display
Notifies a user that the job has been cancelled as permission for
printing has not been received. (Job Account-related) This is
displayed until the ON LINE key is pressed. * Scroll display.
Notifies a user that the job has been cancelled as the log buffer is
full. (Job Account-related) This is displayed until the ON LINE key
is pressed. * Scroll display.
A FLASH error other than No.26 and No.27 has occurred.
Operation that does not use FLASH is possible. * Scroll display
Manual print request. Prompts the user to set paper indicated by
mmmm manually. * Scroll display
To Next Page
Loading...
