42049001TH Rev.1 31 /
Oki Data CONFIDENTIAL
2.2.15 FAN (Fuser) / Belt Motor / High Voltage Power Supply Board / Cover Open Switch / Image Drum
Up/Down Sensor
(1) Remove the left side cover (see section 2.2.2).
(2) Make screw 1 and connector removal to detach the belt motor 2.
(3) Remove the screw 3, disengage the latch and make connector removal to detach the high
voltage power supply board 4.
(4) Remove the two screws 5 to remove the cover-rear 6.
(5) Remove the connector and, turning the FAN (Fuser) 7, detach the FAN (Fuser) 7.
(6) Remove the connector and unlatch the cover open switch 8 to detach the switch.
(7) Remove the connector and pull out the lock-piece 9 to detach the image drum up/down
sensor 0.
Figure 2-2-15 FAN (Fuser) / Belt Motor / High Voltage Power Supply Board /
Cover Open Switch / Image Drum Up/Down Sensor
8
0
9
7
6
5
4
2
1
3
To Next Page
Loading...
Need help?
General
