42049001TH Rev.1 61 /
Oki Data CONFIDENTIAL
3.2.2 EEPROM Replacement after ARC Board / OWL Board Replacement
When ARC board / OWL board replacement, data in user-used board EEPROM is to be copied
onto new boards (to allow new boards to inherit user-defined information and font installation
information). When user-used EEPROMs are unusable due to its problem, new boards, whose
destinations and must have been set, are to be used. Also new-EEPROM destinations must have
been set.
3.2.3 Destination Setting (Check Method: Printing demo page)
Destination setting is to be conducted at final setting after part installation in printers. The
destination setting for each printer, which defaults to ODA, is to be set to the destination of the
printer without exception at the time it is shipped.
Note!
Destination settings are stored in ARC board / OWL board EEPROM.
1. Maintenance-use boards: Destination setting for maintenance-use boards to Japan indirect
sales, ODA, OEL and APS is not performed. They are shipped with the destination settings set
to their default.
2. Setting from operator panel: Each printer is booted in Maintenance mode and its destination is
set.
• While holding the MENU+ and MENU- keys down, turn on the printer.
• After “MAINTENANCE MENU” appears, the display changes to “OKIUSER.”
• Press the MENU+ key, select destination-setting “OKIUSER” and press the ENTER key.
•“JP*” is shown on the lower display.
• Press the ENTER key, select a destination using the MENU+ or MENU- key, and hit the
ENTER key.
• Press the BACK key to confirm the selection.
• Re-starting the printer changes its destination.
3. Description
PX714/715 printers to Japan domestic and overseas destinations share a ROM. Destination
setting must be performed where the ROM is used in printers to other-than-ODA destinations
(destination settings default to ODA). Destination settings are stored in ARC board EEPROM.
Program ROM version changes return destination settings to their initial values. Destination
setting for maintenance-use boards, which destinations are not set at the time of shipment, is
to be carried out when they are used.
To Next Page
Loading...
Need help?
General
