Oki DP-5000 - Removing the SCSI Interface Module; Connecting the Printer to Your Computer

108 User’s Guide
Removing the SCSI interface module
1. Turn off the power to your printer, computer, and
all SCSI devices connected. Remove the power
cable from the wall socket and the printer.
2. To disconnect the SCSI interface module (1) gen-
tly pull the plastic handle (2) at the bottom of the
module to release the catch and lift the module
away from the printer.
Connecting the printer to your computer
Caution 1:
Power to the printer and computer must be turned off and
the power cables unplugged before connecting or
disconnecting the printer cable. Otherwise damage or
malfunction may result.
Caution 2:
For best results use a high-impedance SCSI cable and an
active terminator.
Caution 3:
Using other types of cables can cause the printer to
malfunction.
Connect the SCSI cable (1) to the printer and to the
computer (2). Secure the printer cable to the connectors
on the printer and on the computer.
Note:
Always attach a terminator (3) to the printer if the
printer is the last peripheral on the SCSI chain.
2
1
1
2
3
4