English
Chapter 6 - Maintenance 61
1. Press the front cover release button and gently
lower the front cover.
2. Gently apply the tape (1) to dirty spots on the
platen (2), and rub your finger over the tape.
Caution:
Do not touch or remove the white pad (3) on the left side of
the platen. Doing so may damage the printer.
3. Slowly peel off the tape.
4. Repeat as necessary to remove dirt from the
platen.
Cleaning the feed roller
Use isopropyl alcohol and a cotton swab to clean the
feed roller as described below.
Caution 1:
Do not use benzene, thinner, or other volatile materials, as
they may damage the printer components.
Caution 2:
Do not get the inside of the printer wet.
1. The printer must be initialised for cleaning the
feed roller. To initialise turn off the printer first,
then press the
power
button to turn the printer on
again.
2. Push the front cover eject button and gently lower
the front cover.
3. Press the
ready/insert
button to move the carriage
to a safe position.
1
3
2
To Next Page
Loading...
Need help?
General
