English
Chapter 7 - Troubleshooting 91
Connection method
1 Can I connect multiple DP printers to a single
computer?
If different SCSI device numbers are used, multi-
ple printers can be connected to a single Macin-
tosh. Of course, simultaneous printing is not
possible.
2 Can I connect a single DP printer to multiple
computers?
No, the printer is not designed for this.
Other operational problems
1 Is this printer compatible with PostScript?
The DP-5000 printer uses QuickDraw. It is not
compatible with PostScript.
2 EPS files cannot be output clearly.
Since EPS files are data files for PostScript print-
ers, images at 72 dpi may be output from Quick-
Draw depending on the application.
3 Are enlargements and reductions possible?
Set either the enlargement or the reduction rate in
the
Reduce
or
Enlarge
setting in the
Page Setup
dialogue box. This value may be specified
between 25 and 400.
4 The preview doesn’t change even though I change
the reduction or enlargement in the
Page Setup
dialogue box.
The preview will not change size with different
reduction or enlargement settings. Check the size
after printing to see that the changes took effect.
5 How do I uninstall the printer driver?
Remove the DP-5000 printer driver from the
Extensions
folder in the
System Folder,
and
remove the
DP-5000 Preferences
file from the
Preferences
folder. If you have installed the
Queue Kit
software, and you are not going to use
it with other applications, remove the
Queue
Monitor
and
Queue Watcher
files from the
Extensions
folder. Restart your computer.
6 Can this printer be connected to Windows and
Macintosh computers simultaneously?
No, the parallel port and the SCSI port cannot be
used at the same time. Connect a Macintosh com-
puter to the printer using the Macintosh interface
module, and connect a Windows computer with-
out the module.
To Next Page
Loading...
Need help?
General
