Oki ES6450 - Page 115

Changing settings from the operator panel
- 115 -
Item
Factory
default
settings
Description
Timeout Injob 40seconds Sets the time from loss of the data receipt
(canceled by PostScript Emulation) until
force-printing.
Value range: Off, 5 seconds, 10 seconds, 20
seconds, 30 seconds, 40 seconds, 50
seconds, 60 seconds, 90 seconds, 120
seconds, 150 seconds, 180 seconds, 210
seconds, 240 seconds, 270 seconds, 300
Seconds
Timeout Local 40seconds Sets the time to keep each port open after
printing. (Except for network)
The value range is from 0 to 300 seconds in
increments of 5 seconds.
Timeout Network 90seconds Sets the time to keep the network port open
after printing.
The value range is from 0 to 300 seconds in
increments of 5 seconds.
Low Toner Continue Sets the action of this machine when "Toner
Low" is displayed.
This machine goes offline when [Stop] is
selected.
Print Mode w/o Color Toner Alarm Specifies the action when there is an empty
color toner cartridge.
[Alarm]: This machine stops without printing
the color print data.
Replace the empty toner cartridge with a
new one.
[Cancel]: Cancels color print data
automatically.
Replace the empty toner cartridge with a
new one.
Jam Recovery On Sets whether to reprint pages not printed
due to a paper jam after the paper jam is
cleared.
When [Off] is selected, the printing process
including pages missed due to the paper jam
will be canceled.
Error Report (Fn210) Off Sets whether to print an error report when an
internal error occurs.
Hex Dump (Fn237) Execute Prints the data received from the PC in
hexadecimal dump. To exit this mode, turn
off the power.
Tray
Configuration
MPTray
Config
Paper Size (Fn90) A4 or Letter
*1
Sets the size of the paper you want to print
on from the MP tray.
X Dimension (Fn91) 210
millimeter or
8.5 inch
*2
Sets the paper width when you have
selected a custom size for the paper that you
want to print on from the MP tray.
Y Dimension (Fn92) 297
millimeter or
11.0 inch
*2
Sets the paper width when you have
selected a custom size for the paper that you
want to print on from the MP tray.
Media Type (Fn93) Plain Sets the type of paper that you want to print
on from the MP tray.