Oki ES6450 - Page 223

Management of this machine
- 223 -
Item
Description
Job Limitation Sets whether to save restricted print data.
When [Private Print only] is selected, print data other than private print
will not be accepted.
Verify job password Selects whether to verify the job password when the access control is
enabled.
Job Auto Search Selects whether to perform job search at the same time as unlocking the
panel when the access control is enabled.
Management
Sets the information about this machine.
Item
Description
Local Interface
USB Menu
Sets the information about USB.
Access Control Setup
Sets the access control function.
System Setup Sets various types of actions of this machine in correspondence to
various situations such as unit of measurement and alarm release.
Power Setup
Sets power save, sleep and auto power off.
Panel Setup
Sets the items to be displayed on the screen.
Buzzer Setup Adjusts the volume when an error occurs, when the printing has
completed, when AirPrint is checked, and when the IC card is held up (if
the IC card reader is installed).
Flash Memory Setup
Used to initialize the flash memory and format a partition.
Job Log Setup
Sets whether to save the job log. Also used to clear saved job logs.
Job Cancel Setup
Sets the actions when «CANCEL» is pressed.
Language
Maintenance
Setup
Select Language Sets the language for the screen display, the web page display and the
report printing.
Font Setup
Sets the information about the font output mode.
Admin Password
Sets the admin password.
Paper Feed Roller Counter Clear
Clears the counter after the paper feed roller is replaced.
Settings
Save the data set in [Setting], and initialize the recalling.
Settings Cloning
Settings Import
Transmits settings of this machine which are saved and filed to the PC.
Settings Export
File and save the settings of this machine to a PC.
Print Statistics
Enables or disables the counter of maintenance parts.
User Install
Item Description
Setup
Sets the configurations checked over the network.
Time Setup
Sets the information about SNTP.
Other Settings Sets the notification timing for the replacement of the image drum, fuser
and belt unit.