112
Example (5) Initializing the printer settings
Note on initialization
The initialization procedure does not initialize the paper width and
sensor adjustments.
These values will remain as set the paper layout information will be
initialized except for the paper width.
The initialization procedure is as follows:
1. Before starting work for this setting, verify the following printer conditions:
(1) The power is turned off.
(2) Paper is loaded on the printer.
(3) The cover is closed.
2. Enter special mode.
Turn on the power switch on the right side of the printer while holding
down the FEED switch on the left part of the top cover.
Note: You must hold down the FEED switch until the printer starts printing.
Note: If you have passed the item that you want to select, quickly press the
FEED switch repeatedly until you return to the first item.
To Next Page
Loading...
