61
6-3-3. Automatic layout detection
The automatic layout settings are configured as follows:
Black mark paper
L1: Length from the vertical reference position to the next reference
Position : Automatically detected
L2: Length of the detection area for the vertical reference position
: 5.0mm to 5.5mm
L3: Length from the vertical reference position to the start position
: 1.5mm
L4: Length from the vertical reference position to the cutting position
: 0.0mm
L5: Print area length : (L1 - 1.5 x 2) mm
L6: Length from the left edge of the paper to the left end of the print area
: 11.0 mm (for a paper width of 83 mm)
: 4.0 mm (for a paper width of 80 mm)
: 3.0 mm (for other paper widths)
L7: Print area width : 80.0 mm (for a paper width of 83 mm)
(Paper width - L6 x 2) mm (for other paper widths)
Note: L1 to L7 above are values detected by the printer sensor.
These values do not match the S1 to S5, L, R, T, and B parameter
values specified by the driver or utility.
Note: If the paper length (L1) of the loaded roll paper differs by ±10% or
more from the initially set paper length (L1) or that set upon
automatic recognition, an error occurs because the type of loaded
roll paper is considered illegal.
To Next Page
Loading...
