65
6-5. Paper Layout Errors
When using black mark or die-cut label paper, the printer monitors the
paper length (L1) based on the set paper layout. If the detected paper
length does not match the set paper length, a paper layout error occurs.
(1) Error when paper is being loaded
Confirm that the paper being loaded is the same as the paper specified
in the paper layout information for the printer. If not, replace the paper
with paper that matches the paper layout information.
(2) Error during printing
If a paper layout error occurs during printing, open the top cover, check
whether label peeling, a paper jam or other problem has occurred,
reposition the paper, and then close the top cover.
(3) Error when paper is being replaced
Follow the procedure in "Section 6-4. Replacing paper."
Note: If the paper length (L1) of the loaded paper is ±10% different from
your specified paper length or that set through automatic detection,
a paper layout error occurs.
To Next Page
Loading...
