Oki LD670 - Setting the Roll Paper

215
14-8. Setting the Roll Paper
(1) Insert the paper roll to the included paper roll shaft core and set them in the
large diameter paper roll unit.
Note: To load a new roll paper, first remove the tape and the glued portion at the
beginning of the roll.
Note: The printer cannot print on the glued portion of the paper, so remove
about one turn of the roll paper from the beginning. Any adhesive or other
matter remaining from the glue may stick to the thermal head and cause a
problem such as voids on printouts. For this reason, be sure to remove the
glued portion of the paper.
Note: There is a direction of the installation when the paper is installed. Please
install it like the clause 14-8- (3).
Roll paper shaft
Roll paper