80
10-2. Setting Up the Printer
This section explains how to set up the printer without using a PC.
With the printer connected to a Windows PC, you can easily change the settings
by using the utility software contained on the CD-ROM provided with the
printer.
For details on how to install and run the utility, see "Chapter 3 Installation" in
the
Installation Guide
.
For details on the functions of the utility and how to use it, see the
Utility User's
Guide
.
This section describes the typical setting changes listed below in detail.
Example (1) Changing the print density to a lower value
Example (2) Changing the print speed to a higher value
Example (3) Changing to use two-color thermal paper
Example (4) Changing the top-of-form position at power-on
Example (5) Initializing the printer settings
Example (6) Disabling paper-near-end detection
Example (7) Changing the paper width
Example (8) Switching to batch printing
To Next Page
Loading...
