Oki LD670 - Conditions for Using Die-Cut Label Paper

20
3-4-3. Conditions for using die-cut label paper
When using die-cut label paper, confirm that the following conditions are
satisfied. When using die-cut label paper with black marks, confirm that
the conditions stated in Section 3-4-2, "Conditions for using black mark
paper," are also satisfied.
Note: The base paper's opacity (ISO) must be equal to or less than 70%.
Print area
Printable side of paper
Paper feed direction
2
±
0.5 mm
3 to 10 mm
Label
Base paper
15 to 101.6 mm
2
±
0.5 mm
4.5 mm or more
4.5 mm or more
1.5 mm or more
1.5 mm or more