62
Die-cut label paper
L1: Length from the vertical reference position to the next reference position
: Automatically detected
L2: Length of the detection area for the vertical reference position
: Automatically detected
L3: Length from the vertical reference position to the start position
: (L2/2 + 1.5) mm
L4: Length from the vertical reference position to the cutting position
: 0.0 mm
L5: Print area length : (L1 - L3 x 2) mm
L6: Length from the left edge of the paper to the left end of the print area
: 5.0 mm
L7: Print area width : (Paper width setting - L6 x 2) mm
Note: L1 to L7 above are values detected by the printer sensor.
These values do not match the S1 to S5, L, R, T, and B parameter
values specified by the driver or utility.
Note: If the paper length (L1) of the loaded roll paper differs by ±10% or
more from the initially set paper length (L1) or that set upon
automatic recognition, an error occurs because the type of loaded
roll paper is considered illegal.
To Next Page
Loading...
