63
Plain paper (including full-sheet label paper)
L1: Length from the vertical reference position to the next reference position
: Not determined
L2: Length of the detection area for the vertical reference position
: Not determined
L3: Length from the vertical reference position to the start position
: Not determined
L4: Length from the vertical reference position to the cutting position
: Not determined
L5: Print area length : Not determined
L6: Length from the left edge of the paper to the left end of the print area
: 1.0 mm (for a paper width of 83 mm)
: 4.0 mm (for a paper width of 80 mm)
: 3.0 mm (for other paper widths)
L7: Print area width
: 80.0 mm (for a paper width of 83 mm)
(Paper width - L6 x 2) mm (for other paper widths)
Note: L1 to L7 above are values detected by the printer sensor.
These values do not match the S1 to S5, L, R, T, and B parameter
values specified by the driver or utility.
To Next Page
Loading...
