132
10. Select "END" as your option.
Quickly press the FEED switch three times (up to one second each) to
move to "END".
Then press and hold down the FEED switch for at least one second to accept
the selection.
After you accept “END” selection, the printer cuts the paper and exits
from setup mode.
Note: If you turn off the printer power switch without first selecting "END",
your settings will be lost.
- Verifying your settings
To verify your settings, execute a test print as described in Section 10-1.
The test printing prints a list of printer settings. Check the list
to verify your settings.
End
↑
Default Set
↑
Setup Print
↑
Setup
End
Default Set
Setup Print
Setup
To Next Page
Loading...
