Oki LD670 - Page 144

143
№
Item
Explanation
Detailed setup item
3
Base Adjustment
Specifies the value used for batch
correction of the start position,
cutting position, peeling-off
position and tear-off position.
-5.0 mm
-4.X mm
-3.X mm
-2.X mm
-1.X mm
-0.X mm
0.0 mm
+0.X mm
+1.X mm
+2.X mm
+3.X mm
+4.X mm
+5.0 mm
When "-4.X mm" is selected
-4.0 to -4.9 mm
When "-3.X mm" is selected
-3.0 to -3.9 mm
When "-2.X mm" is selected
-2.0 to -2.9 mm
When "-1.X mm" is selected
-1.0 to -1.9 mm
When "-0.X mm" is selected
-0.0 to -0.9 mm
When "+0.X mm" is selected
+0.0 to +0.9 mm
When "+1.X mm" is selected
+1.0 to +1.9 mm
When "+2.X mm" is selected
+2.0 to +2.9 mm
When "+3.X mm" is selected
+3.0 to +3.9 mm
When "+4.X mm" is selected
+4.0 to +4.9 mm