Oki LD670 - Page 190

189
(3) DIP switches
Note: The DIP switches are provided for maintenance purposes. All DIP
switches should be left OFF during normal operation.
No.
ON
OFF
1
-
Off (fixed)
2
Setup information initialization
-
3
Setup information
-
4
Self-diagnosis printing
-
Procedure for initializing setup information
1) Turn off the printer power.
2) Set switch 2 to ON.
3) Turn on the printer power. Initialization takes about five seconds.
4) Turn off the printer power.
5) Set switch 2 to OFF.
Procedure for test printing from the LAN board
1) Turn off the printer power.
2) Set switches 3 and 4 to ON.
3) Turn on the printer power to start test printing.
4) Turn off the printer power.
5) Set switches 3 and 4 to OFF.
Note: Be careful when setting the DIP switches.
4 3 2 1
ON