Oki LD670 - Page 218

217
(2) Set the paper width by positioning the partitions in the roll paper unit.
[1] Orient the paper roll along the direction arrow A.
[2] Loosen the knob screws front and back that fix the partition.
[3] Align the partition to the width of the paper roll, and slide in the direction
of the arrows B.
[4] Fix the partition leaving a slight gap as shown in the diagram.
Front: Leave a gap of one gradation on the scale between the partition and
the paper roll, and then tighten the (front) knob screws to fix.
Back : Leave a gap of one 1 to 3mm using the scale between the partition
and the paper roll, and then tighten the (back) knob screws to fix.
Front
Rear
Partition
Thumbscrew (front)
Thumbscrew (rear)
B
B
Roll paper
A
Front
Rear
Space of 1 division in
scale on label
Partition Partition
Roll paper
Space of 1 to 3 mm