88
10. Select "END" as your option.
Quickly press the FEED switch three times (up to one second each) to move to
"END".
Then, press and hold down the FEED switch for one second or longer to
accept the selection.
The printer cuts the paper and exits from setup mode when you accept the
selection of "END".
Note: If you turn off the printer power switch without first selecting "END",
your setting will be lost.
- Verifying your setting
To verify your setting, execute a test print, referring to Section 10-1.
The test printing prints a list of printer settings. Check the list,
and verify your setting.
End
↑
Default Set
↑
Setup Print
↑
Setup
End
Default Set
Setup Print
Setup
To Next Page
Loading...
Need help?
General
