- 147 -
5. Fax
Setting Scanning for Transmission
This section describes how to make settings when sending a fax.
• Scanning a Duplex Document (Duplex Scan)
• Specifying a Scan Resolution (Resolution)
• Sending a Fax to Multiple Destinations at the Same Time
• Specifying a Scan Size (Scan Size)
• Adjusting the Density (Density)
• Scanning a Document with a Colored Background Clearly (Background Removal)
• Erasing Edge Shadows When Sending (Edge Erase)
• Disclosing a Sender Name (Originator) to the Recipient
• Changing the Sender Name That is Printed on Faxes
• Printing Transmission Results Automatically (Transmit Conf. Report)
• Registering the Sender Name (Originator)
• Changing the Standard Originator Name
• Adding a Prefix (Prefix)
• Setting the Number of Redial Attempts and Redial Intervals
You can send a duplex document by fax with the ADF.
When you set a document on the document glass, this function cannot be used.
1
Press the (FAX) button on the operator panel.
2
Set a document in the ADF.
3
Check that [Fax] is selected, and then press the button.
4
Press the button to select [Fax Functions] and press the button.
5
Press the or button to select [Duplex Scan] and press the button.
6
Press the or button to select the value you want to set and press the
(OK) button.
You can specify [Long Edge Bind] or [Short Edge Bind].
7
Press the button until the start screen is displayed.
8
Specify a destination.
Entering Fax Number to Send a Fax (User's Manual)
Specifying a Destination from Phone Book
Specifying a Destination Using One-touch Button
Specifying a Destination from Transmission History and Reception History
9
Change other settings if necessary, and then press the (MONO) button.
Scanning a Duplex Document (Duplex Scan)
To Next Page
Loading...
Need help?
General
