Oki MPS5502 - Page 353

45641001TH Rev.1
11-55 /
Oki Data CONFIDENTIAL
05/
08
Mode Element
Sub
element
Item Subitem Code
Sub-
code
Details
Default
value
Acceptable
value
RAM Contents
Proce-
dure
08 Setting
Mode
System General Memory 9020 Size information of
memory
- - SYS Displays the sizes of the main memory and page memory.
Enables to check if each memory is properly recognized.
2
08 Setting
Mode
System Initialization 9030 Initialization after
software version
up
- - SYS Performthiscodewhenthesoftwareinthisequipment
has been upgraded.
3
08 Setting
Mode
System User
interface
Counter installed
externally
9037 Job handling-short
paid-coin controller
1 0-1 SYS Setswhetherpauseorstoptheprintingjobwhenitis
short paid using a coin controller.
0:Pausethejob
1:Stopthejob
1
08 Setting
mode
System FInisher Finisher tray
operating mode
9048 0 Operating mode 1 0 0-1 SYS Forplainpaper,thick1,LG.Fornon-sortmodeand
sort mode. Do not change this setting unless otherwise
instructed.
0: Disabled 1: Enabled
4
08 Setting
mode
System FInisher Finisher tray
operating mode
9048 1 Operating mode 2 0 0-1 SYS For thick 2. Do not change this setting unless otherwise
instructed.
0: Disabled 1: Enabled
4
08 Setting
mode
System FInisher Finisher tray
operating mode
9048 2 Operating mode 3 0 0-1 SYS For thick 3. Do not change this setting unless otherwise
instructed.
0: Disabled 1: Enabled
4
08 Setting
mode
System FInisher Finisher tray
operating mode
9048 3 Operating mode 4 0 0-1 SYS For thick 4. Do not change this setting unless otherwise
instructed.
0: Disabled 1: Enabled
4
08 Setting
mode
System FInisher Finisher tray
operating mode
9048 4 Operating mode 5 0 0-1 SYS ForLG.ForSingle-sidedstapling.Donotchangethis
setting unless otherwise instructed.
0: Disabled 1: Enabled
4
08 Setting
mode
System FInisher Finisher tray
operating mode
9048 5 Operating mode 6 0 0-1 SYS For single-sided stapling. Do not change this setting
unless otherwise instructed.
0: Disabled 1: Enabled
4
08 Setting
mode
System Scanning 9049 Scanning operating
mode
0 0-1 SYS Do not change this setting unless otherwise instructed.
0: Operating mode 1
1: Operating mode 2
1
08 Setting
Mode
System
Maintenance General 9050 Performing panel
calibration
- - SYS Performs the calibration of the pressing position on the
touchpanel(LCDscreen).
The calibration is performed by pressing 4 reference
positions after this code is started up.
1
08 Setting
Mode
System User
interface
Display setting 9051 Panel calibration
setting value
0 0-1 SYS Switches whether the screen for displaying panel
calibration setting values is displayed or not.
0: Disabled (screen not displayed)
1: Enabled (screen displayed)
1