22 Control Elements
4.3 Measuring probes and sensors
Each measuring probe that you attach to the telescopic rod assembly is optimized for its very special
task. The eXp 6000 supports following probes:
• Telescopic Probe
This horizontal probe is perfectly used to scan wide areas in short time. You can extend its
length between 50 and 120 cm. The optimal length depends on the field dimensions and the size
of the object you are looking for. This probe can be used for following operating modes:
◦
Ground Scan, Magnetometer
• Super Sensor
This vertical probe is the most sensitive probe of all and thus perfectly used for finding small
amounts of metal (prospecting, mining) as well as pin pointing. This probe can be used for
following operating modes:
◦
Ground Scan, Magnetometer, Pin Pointer, Mineral Scan
• Tunnel Sensor
This vertical probe has been developed to find underground caves, tunnels, tombs and the like. It
can be used for following operating modes:
◦
Ground Scan, Tunnel Scan
• LiveStream Sensor
This horizontal probe is a very special one that can be used to scan a high amount of data. Thus
it is able to generate live images to visually pinpoint underground objects. This probe can be
used for following operating modes:
◦
Ground Scan, Live Scan
Figure 4.4 shows the control elements exemplary for the Telescopic Probe.
OKM GmbH
www.okmmetaldetectors.com
To Next Page
Loading...
