OKM eXp 6000 - Telescopic Probe, Livestream Sensor; Parallel or Zig-Zag

Field procedure 79
You have to raise the probe (increase the distance to the ground).
You have to turn the probe to the right side.
You have to turn the probe to the left side.
7.3.1.2 Telescopic Probe, LiveStream Sensor
The following table explains the symbolism of all horizontal probes. There are images with 1 arrow (low
inclination) and 2 arrows (high inclination).
Low
inclination
High
inclination
Correction
You have to lower the probe (decrease the distance to the ground).
You have to raise the probe (increase the distance to the ground).
You have to turn the probe to the right side.
You have to turn the probe to the left side.
7.3.2 Parallel or Zig-Zag?
For skilled users of the eXp 6000 both scan modes are suitable. According to experience the best
graphics have been received in the “Parallel” mode, because you are starting at the same point and
walking in the same direction. It is also easier to control your walking speed and direction.
OKM GmbH
www.okmmetaldetectors.com