Olympus BH2 Series - Page 74

13-3 Center the prism in the following procedures:
Assemble the following Jigs, and B2-BI, B2-
TRC Units on the Microscope Stand.
Standard objective: KNOU05
1 Ox eyepiece with cross hair: C-1
(See Fig. 13-51
NOTE:
Assemble B2-BI Unit with B2-TRC
Unit, refer to 1 1-3-5 a).
P-
Condnnsnr
Fig. 13-5
Fig. 13-6
13-3-1 Insert C-1 to sight side Eyepiece sleeve.
. ,
13-3-2 Adjust position of Dovetail ABO33500 until
C-1 is centered with the center cross hair on
4 KN 0005. (See Fig. 1 3-61
13-3-3 Check Shaft AB034300 movement. If it
shows too much friction, adjust position of
Cover AA581100.
13-3-4 When optical alignment is impossible, check
Prism ZA071000 and Circular Dovetail AB-
034200 for their positions.
13-3-5 lnsert C-1 into left Eyepiece sleeve, and
check that: the deviation of the left eyepiece
axis is within two divisions, if any, from the
right eyepiece axis.