Olympus BH2 Series - Page 73

- 'd
Prism fixing block -
2KC0404
- Lock screw
Fig. 33-3
- - - --
Fig. '1134
g) Adjust operation of the click by moving
screw AA063200 in or out.
h) After placing Prism Mount AB033300 and
Dovetail AB033500 on Positioning Jig
B2KC0404, clamp them by tightening the
two knobs located on the Jig.
i)
l nsert Prism ZA07100Q into Prism Mount
AB033300, After turning the Prism
Clamp located on the Jig to the prism side,
pus11 thc! Prism info the Prism Mount
and tiqhtan the lock screw on the Jig.
i)
Tiqlitnn two Screws HU3x4SA located on
thr! PrEsrn Mount,
k)
Remove thv Prism Mount unit from the
Jig ancl apply n srnnll amount of Adhesive
OTT 078 nr tour points (same place where
Adh~sivr wnq npplicrl before disassembly 1.
1)
Assernl)lr! Prim LP094600 as per fallow-
ing:
(1) Droo Prisrn LP094600 into the Prism
Mnurit.
(2) Apply Atlt~r.;ivr! Agent OT1131 to the
ti0 of Scrrws HU3x4SA and then
t iqhrtnn Ilw screws.
n~rnovn .Ilq t32KC0404. After con-
jirrnir~q tirllltcned condition, apply
Sh~llrlc. OT 1 131 to each Screw.
(3) Aqsr3rril)l~ thv light path selector
tinil will1 Ilotly A0933100 by using
ftjrrr Scrcws AR3x8SA.
(See Fig, 1 3-41
(4) Aasemhlt! Knob AB034400 with Shaft
ARO34300 (apply Adhesive OT1126).
(5) Assemble Shaft A8034300 with the
Rotly (apply Adhesive 0T1126).