13-4 Adjust tube length B2-BI Unit
For the procedure to adjust tube length, refer to
AB3x40SA
11-5.
13-5
Asseml~le the Phototube Unit in the procedure
given below:
13-5-1
Asserii1)le Wasllc?rs (lo
be
selected from among
AB033800 It~rorr$jh AR034100) and Mount
ABO336C30 with Cover AB033200 by using
three
Scrcws AB3xrlOSA.
(See Fig. 13-7)
13-5-2 Assemble
III(?
I'llotot~rl)c Unit with the body
by
usillq two Si;~c!wt; AU4x45SA and two
Screws
AU4x2!sSA.
(:"I
5
"
Ill-($
Oplicill ;~li!jrrlnoll. ant1 19~rfocalil.y alignment for
Plwt ot~rl,c Ullil
13-6-1 Parivcalil y alignment
a)
I"lirco ~lic following Jigs on the Microscope
SLitt~(l
as
shown in Fig. 13-8:
B?l<(:0406: lnterpupillary distance jig
I<NOO22: Special W F
I
Ox
C
15: Focusing magnifier
Oiological specimen
1-U40x objective
Biological specimen
1))
Carry out steps b) and c) of 11-5-1 (given
lot- BI-12-BI)
c)
Bring the specimen into focus by turning
Lhc Fine Adjustment Knob.
d)
Place KN0022 and C-15 into the
Pliototube.
e)
Move the front lens portion of KN0022
until the specimen
is
brought into focus
'I
and read indication on the scale.
1
I
--
72
-
Fig.
13-8
To Next Page
Loading...
