Olympus BH2 Series - Page 76

f) If deviation exceeds 1 division on the
scale of
KN0022, adjust Washers (selected
from among
AB033800 through AB-
034100) for proper focusing.
STANDARD:
0.1 mm on the phototube side taking the
rig171 side of fll as STANDARD (Within
I 1 division on the scale of KN0022).
13 6 2 O~)li~:~~l aIiqnt~ic?~it
,I)
I'ltac:(x BIi2TR and the following Jigs on
LBI OX ol)jc~c:~ IVI'
i1111 MICI oscol,c Stand as shown in Fig. 13-
$1 :
li21<(;0/10(i: I~~lt:tpcry,illary distance jig
II~I<(;IO~~~: Aliryir~~(:t~t jig
l<N0(104 : I l)l:~ti?
3t1W I I It 1 Ox: I oc:~~sillcj c?ycl)it?cc
LB I Oxol)jc!cl ivc?.
(Sce Fig. 13-9)
Fig. 13-10
,35WHK
Bi side
Fig. 13-1 1
b) Clamp B2KC1408 on Phototube AB-
033600 with mark "0" on the latter
matched with mark
"o" on the former.
(See Fig. 13-1
0)
Rotate the front lens portion of Alignment
Jig
B2KC1408 until the image of the
cross hairs
is brought into focus.
C)
Insert 35WH KlOx into the right side Eye-
piece Sleeve of
BI unit. Shift KN0004 on
the stage until the center cross hair of
KN0004 is aligned with the double cross
hair of
35WHI<lOx.
(See Fig. 13-1 1)